TimeExposure Community Forum ~ View topic

Joined: 08 Mar 2010 Posts: 2 Location: virginia

When my lab prints a composite, the perfectly white part of the bevel (on the right and bottom of the image) just blends in with the mat. They're not sure how to print it better so the slightly off-white that is the mat will still look "white" and also allow the bevel to show. Any ideas?

Joined: 11 Jan 2006 Posts: 144

There is a Preference setting for this.
(Check the ProSelect v4.1.6 Manual on page 137 for this and more).

Cheers
Jenni

Joined: 08 Mar 2010 Posts: 2 Location: virginia

Thank you. That definitely helps. But I don't have version 4. I have 3.2.2 So I went to the manual for it and found Layout styles and I see where I can change the color of the mat. In the manual on page 87 it shows a menu that lets you change the percentage you want to darken a mat with a white bevel. Mine does not have that. I just have to choose a custom color and guess at how gray to make it. Am I still missing something?